ABB CI867K01 3BSE043660R1 Modbus TCP Interface
Description:
CI867K01 is designed as ABB 800xA system communicate card. The CI867/TP867 can be used to connect an AC 800M controller to external Ethernet devices using Modbus TCP protocol.
The TP867 Baseplate has two RJ45 Ethernet connectors, where CH1 connector can use 10Mbps or 100Mbps (Mega bits/sec.) and CH2 use10Mbps only.
The baseplate has a code lock that prevents the installation of an incorrect type of unit onto the TP867 Baseplate.
The CI867 expansion unit contains the CEX-Bus logic, a communication unit and a DC/DC converter that supplies appropriate voltages from the +24 V supply via the CEX-Bus. The Ethernet cable must be connected to the main network through an Ethernet Switch.
The CI867 is powered from the processor unit via the CEX-Bus and no additional external power source is required.

Q&A:
1. How to install the CI867K01?
Use the following procedure to install the CI867/TP867:
1.Mount the unit onto the DIN-rail, see Mounting AC 800M Units onto DIN-Railon and Installing the PM86x/TP830 Processor Unit in Single Configurationon.
2.Connect the 10/100Mbps Ethernet twisted pair cable to the CH1 connector on the baseplate.
3.Connect the other end of the Ethernet cable to a Fast Ethernet network via standard Ethernet components.
4.Connect the 10Mbps Ethernet twisted pair cable to the CH2 connector on the baseplate.
5.Connect the other end of the Ethernet cable to a Ethernet network via standard Ethernet components.

2. What's the feature of CI867K01？
• Provides one 10/100Mbps Fast Ethernet port, (RJ45 connector located on the TP867 Baseplate).
• Provides one 10Mbps Ethernet port, (RJ45 connector located on the TP867 Baseplate).
• Simple DIN-rail mounting.
• Provides communication with Modbus TCP protocol via Ethernet. 
• Pre-set, two-letter Alpha code locking device installed in unit base prevents mounting of incompatible components.
• Supports hot swap.