GSI127 Galvanic Separation Unit: Upgrade for Obsolete GSI122

Time: November 16, 2026
GSI127 Galvanic Separation Unit: Authorised Upgrade for Obsolete GSI122

GSI122 Reaches End‑of‑Service
GSI122 (part number 244‑122‑000‑20) has been phased out from the product line. It has been widely used in turbine, compressor and rotating‑machine vibration monitoring chains. GSI122 provide power to transducers and conditioners and collect their output signals. For end‑users aiming to minimise unplanned downtime and preserve maximum production efficiency, upgrading to the GSI127(Part number 244-127-000-021)has become an inevitable industry trend.

Key Features of GSI127
▪ 4 kV RMS sensor‑to‑monitor galvanic isolation; 50 V RMS floating output isolation
▪ Dual signal transfer: µA‑mV for long‑distance, V‑V for short‑range signal transmission
▪ Quick‑release removable screw terminals for easier on‑site maintenance
▪ TH35 standard DIN‑rail mounting for modern control cabinets
▪ Global hazardous‑area certifications (ATEX, IECEx, CSA‑US, KGS); no extra Zener barriers required
▪ SIL 2 compliance for safety‑critical machinery protection systems
▪ Full compatibility with legacy Vibro‑Meter sensors and conditioners
▪ 0‑70 °C operating range with robust EMC noise immunity

Core Hardware and Performance Improvements of GSI127
GSI127 acts as the official successor, preserving full compatibility with existing sensor chains while delivering tangible technical upgrades. It effectively suppresses frame voltage noise that frequently troubles older GSI122 installations. Its redesigned internal floating output removes dependency on auxiliary power accessories such as APF19x series units. The module fits seamlessly into established monitoring environments, requiring no modification to host system firmware. Compared to GSI122’s fixed potted housing and hard‑wired lugs, mechanical upgrades drastically cut downtime during maintenance events.
GSI127 244-127-000-021
Critical Practical Notes for On‑Site Replacement
Even though GSI127 matches measurement‑chain logic, it is not plug‑and‑play. Terminal pin assignments differ completely from GSI122, so technicians must re‑wire every channel instead of direct swapping. Project engineers must select correct ordering codes: A2 Ex‑certified variant is mandatory if replacing GSI122 within explosive‑zone loops, while the B‑suffix code has to replicate the original GSI122 sensitivity and zero‑offset settings to avoid distorted vibration readings. After hardware fitting, complete channel calibration and signal verification are compulsory. Downstream or host monitoring card configurations normally remain unchanged, no system firmware update is necessary.

Final Thoughts
For sites still operating GSI122‑based monitoring systems, migrating to GSI127 removes end‑of‑life component risks without redesigning your whole vibration measurement architecture. Properly matched part codes and careful commissioning guarantee stable, long‑term performance for safety‑related rotating‑machinery protection.

Send Us An Inquiry

Send Us An Inquiry
If you are interested in our products and want to know more details,please leave a message here,we will reply you as soon as we can.

Home

Products

whatsapp