IPC704 244-704-000-042 A1-B03-C100-D77-E2-F5000-G0-H0-I0 Signal Conditioner

Description:
The IPC704 244-704-000-042 A1-B03-C100-D77-E2-F5000-G0-H0-I0 is a signal conditioner designed to process charge-based signals from compatible piezoelectric transducers. It converts the sensor signal into a current or voltage output that can be transmitted to downstream monitoring and processing equipment. 

This configuration uses a B03 transfer function, with a pC/g input and μA/mm/s output. It also features a 2 Hz high-pass filter and a 5,000 Hz low-pass filter, providing defined signal cibonditioning for vration measurement applications. The A1 configuration represents the standard environmental option, while G0 specifies the signal conditioner without the optional industrial housing. 

With its configurable signal conversion and filtering functions, the IPC704 can be integrated between piezoelectric sensors and monitoring electronics used for rotating machinery and other dynamic measurement applications.

Application Value:

For Turbine and Rotating Machinery

The IPC704 provides signal conditioning between compatible piezoelectric sensors and monitoring equipment, helping convert vibration signals into a form suitable for machinery condition monitoring. Its configured signal path can be applied to turbines, compressors, pumps and other rotating equipment.

For Controlled Vibration Signal Transmission

The configured filtering and current-output function helps prepare sensor signals for transmission to downstream monitoring equipment. This is useful in installations where reliable signal conditioning is required between the sensor location and the monitoring system.

The configured 2 Hz high-pass and 5 kHz low-pass filtering can be used to control the frequency content passed to the monitoring system, according to the requirements of the measurement application.

Expert Advice

Check the Complete Signal Configuration Before Replacement

When replacing this IPC704 configuration, engineers should verify the complete ordering code rather than matching only the base model. The B03 signal conversion, C100/D77 configuration and E2/F5000 filter settings should be consistent with the existing sensor and receiving equipment.

Keep the Sensor and Monitoring Chain Matched

The signal conditioner works as part of the complete sensor → conditioner → monitoring system chain. Before installation, engineers should confirm that the replacement unit is compatible with both the connected piezoelectric sensor and downstream monitoring equipment to avoid changes in the measured signal.

C: INPUT SENSITIVE
D: OUTPUT SENSITIVE
E: High-pass filter
F: Low-pass filte
G: INSTALLATION
0  Signal conditioner only
1 Signal conditioner with industrial housing
2 Signal conditioner mounted on mounting adaptor
H: INPUT CABLE FITTING

I: OUTPUT CABLE FITTING